User Tools

Site Tools


add_chacon_di.o_remote_control_support_in_domoticz

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
add_chacon_di.o_remote_control_support_in_domoticz [2017/01/02 19:26]
sgripon [Arduino sketch]
add_chacon_di.o_remote_control_support_in_domoticz [2017/01/02 19:27]
sgripon [Domoticz]
Line 108: Line 108:
 ===== Domoticz ===== ===== Domoticz =====
  
-In domoticz, add a device ​"​MySensors USB Gateway"​. Check that serial port is properly configured. Default one should be good in raspberry pi. Then, plug the arduino on the raspberry pi with USB. You should see the detected MySensors gateway on domoticz logs:+In domoticz, add a hardware ​"​MySensors USB Gateway"​. Check that serial port is properly configured. Default one should be good in raspberry pi. Then, plug the arduino on the raspberry pi with USB. You should see the detected MySensors gateway on domoticz logs:
  
   2017-01-02 19:​21:​02.562 ​ MySensors: Using serial port: /​dev/​ttyACM0   2017-01-02 19:​21:​02.562 ​ MySensors: Using serial port: /​dev/​ttyACM0
Line 118: Line 118:
   2017-01-02 19:​21:​08.695 ​ Incoming connection from: 192.168.0.43   2017-01-02 19:​21:​08.695 ​ Incoming connection from: 192.168.0.43
  
-And switches are properly ​detcted. You should be able to add them in the following ​domoticz view:+And switches are properly ​detected. You should be able to add them in the devices ​domoticz view:
  
-{{ ::​domoticz-di.o.png?300 |}}+{{ ::​domoticz-di.o.png |}}
  
 **Share this page:** **Share this page:**
  
 ~~socialite~~ ~~socialite~~
add_chacon_di.o_remote_control_support_in_domoticz.txt ยท Last modified: 2017/01/02 19:35 by sgripon