User Tools

Site Tools


add_chacon_di.o_remote_control_support_in_domoticz

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
add_chacon_di.o_remote_control_support_in_domoticz [2017/01/02 19:09]
sgripon [Arduino sketch]
add_chacon_di.o_remote_control_support_in_domoticz [2017/01/02 19:35]
sgripon [Add Chacon DI.O remote control support in Domoticz]
Line 1: Line 1:
 ====== Add Chacon DI.O remote control support in Domoticz ====== ====== Add Chacon DI.O remote control support in Domoticz ======
- 
-** :!: TUTORIAL UNDER CONSTRUCTION :!: ** 
  
 ~~socialite~~ ~~socialite~~
Line 105: Line 103:
  
 </​file>​ </​file>​
 +
 +===== Domoticz =====
 +
 +In domoticz, add a hardware "​MySensors USB Gateway"​. Check that serial port is properly configured. Default one should be good in raspberry pi. Then, plug the arduino on the raspberry pi with USB. You should see the detected MySensors gateway on domoticz logs:
 +
 +  2017-01-02 19:​21:​02.562 ​ MySensors: Using serial port: /​dev/​ttyACM0
 +  2017-01-02 19:​21:​04.214 ​ MySensors: Gateway Ready...
 +  2017-01-02 19:​21:​04.293 ​ (MySensors Gateway USB) Lighting 2 (DI.O Prise 1)
 +  2017-01-02 19:​21:​04.300 ​ MySensors: Gateway Version: 2.1.0
 +  2017-01-02 19:​21:​04.299 ​ (MySensors Gateway USB) Lighting 2 (DI.O Prise 2)
 +  2017-01-02 19:​21:​04.303 ​ (MySensors Gateway USB) Lighting 2 (DI.O Prise 3)
 +  2017-01-02 19:​21:​08.695 ​ Incoming connection from: 192.168.0.43
 +
 +And switches are properly detected. You should be able to add them in the devices domoticz view:
 +
 +{{ ::​domoticz-di.o.png |}}
  
 **Share this page:** **Share this page:**
  
 ~~socialite~~ ~~socialite~~
add_chacon_di.o_remote_control_support_in_domoticz.txt ยท Last modified: 2017/01/02 19:35 by sgripon